https://www.chinastreetlight.com/info-detail/street-light for led streetlight, solar streetlight price, quotation.

https://www.chinastreetlight.com/info-detail/street-light for led streetlight, solar streetlight price, quotation.

@gergling said in Hi, my name is Greg:

This is my first time with robotics. I played a little with lego in the past. I'm a full time software developer though and TV/computer game characters capable of engineering always make me feel inadequate. Then someone got me a codrone for my birthday.

lego is good ideas
solar street light

@lexbot2-0 We will be emailing you to send out a replacement board. Thank you for your patience!

@robolink_leila The broken link was in the earlier reference in your message when I first joined the forum. I have been using that link for a short while and just recently tried it again when I got the error message. Thank you for the information and working new site!

@robolink_leila Thanks!

I'd just urge that when done, the page the instructions lead you to has some link titled "Assembly Instructions" as a start. We finally did find them got it installed with wires connected wrong for 45 minutes and then have been enjoying the drone since!

Great, thanks for the ideas!

@alex Welcome! Let us know if you have any questions!

@elpoole The remote can be powered from either the battery pack or the Micro USB. I recommend using the battery pack for power when you are flying manually, but for testing any autonomous code it's better to leave the switch off and power solely with the MicroUSB since you be reuploading code regularly. If the MicroUSB is plugged in the switch doesn't affect the power. If your drone isn't flying too high you might need to charge your CoDrone battery.

To answer your second question, any code that you upload will be stored the next time you turn on the drone. Any time you want to change the code you will need to upload. If you would like the default remote control again, you need to upload the Flight Controller code again from Examples 🙂

Let me know if you have any more questions!

Hi @Sharp45 ! We actually recommend using Blockly for CoDrone for any block-based programming. You can find our tutorials for those on Workbench. You will not need the Bluetooth board or any additional driver installations for Blockly but make sure to check the minimum requirements. If you are still having connection issues, let me know and I can set up a support call with you. Hope this helps!

@Ken They both give temperature readings but from different chips, one from the gyroscope and one from the barometer. They return the internal temperature of the integrated circuit, not of the ambient temperature where you are flying the drone.

@reggiehg Please send the calibration videos to leila@robolink.com. For the calibration, the remote should be off. If you are still having trouble you can go ahead and check if the button is damaged or missing by carefully removing the top half of the chassis. If you do this, remove the motors and guards first. Could you also send me the file for the IR sensor code that isn't working?

For pairing multiple drones, pair one at a time using CoDrone.pair(Nearest). Label each CoDrone/controller pair with either a number, sticker, or color so that you know which are paired. The next time you want to connect, grab the same CoDrone/controller pair and make sure to use CoDrone.pair() with no parameters. This will ensure the controller only pairs to the drone it most recently paired to.

@idealist333 ,
Please send an email to info@robolink.com and someone will be in touch with you. Thank you for your interest!