Welcome to the Robolink Community forum!
programmer is not responding
-
I'm having the exact same issue.
It used to upload fine. But then I started getting this problem:
Re: error code while uploading
I have reinstalled driver, I've checked port.
I keep getting this error no matter what example code I use.
Any help is appreciated.
Also, the bluetooth module is flashing green in the upload mode, even though red is expected (in the tutorial). -
@Guled30 I sent you a link to the website where you can install the USB driver for your operating system
When you download the files, extract them and run the driver disk. Inside there is a separate folder for the "Legacy" version. For your machine, you will most likely need to run this version, sometimes twice. This will allow your code to upload to CoDrone. Let me know if you have any more questions.
-
@robolink_leila I do not understand what you are saying.
-
@Guled30 Please try installing the driver again. When you extract the files, you will find the Mac "Legacy" version of the driver. Run this installer instead and reopen Arduino. Your port should show up. If not, you may either have to run the installer again or find another USB cable. Hope this helps!
-
-
Sorry, for saying that because now I understand but I do not have SLAB_USBtoUART in my Ports list.
-
Hello, I do not understand what you are saying.
-
@guled30 You are connected to the Bluetooth port. Please look for SLAB_USBtoUART in your Ports list
-
list item
-
@guled30 If you still need help solving your issue, please attach a screenshot or video.
-
Hello, I have the same problem too.
-
@bobbyjohnstx ,
I may be able to help you with your issue! Could you post a picture of your setup (remote and BLE board)? -
@robolink_arnold I have the same issue. I have about 12 Robolink controllers. All of them will upload correctly, but one seems to have developed this issue.
I have a video of trying to upload the Battle Controller sketch.
-
hello @antn23 if the BLE module is green then the remote is communicating to the CoDrone and not to the computer. When trying to upload code to the remote make sure the CoDrone is off. The BLE module should be blinking red, please check out this tutorial. If you are still having issues please send me a video so I can help troubleshoot. Let me know if you have any other questions.