Welcome to the Robolink Community forum!
programmer is not responding
-
@Guled30 Please try installing the driver again. When you extract the files, you will find the Mac "Legacy" version of the driver. Run this installer instead and reopen Arduino. Your port should show up. If not, you may either have to run the installer again or find another USB cable. Hope this helps!
-
-
Sorry, for saying that because now I understand but I do not have SLAB_USBtoUART in my Ports list.
-
Hello, I do not understand what you are saying.
-
@guled30 You are connected to the Bluetooth port. Please look for SLAB_USBtoUART in your Ports list
-
list item
-
@guled30 If you still need help solving your issue, please attach a screenshot or video.
-
Hello, I have the same problem too.
-
@bobbyjohnstx ,
I may be able to help you with your issue! Could you post a picture of your setup (remote and BLE board)? -
@robolink_arnold I have the same issue. I have about 12 Robolink controllers. All of them will upload correctly, but one seems to have developed this issue.
I have a video of trying to upload the Battle Controller sketch.
-
hello @antn23 if the BLE module is green then the remote is communicating to the CoDrone and not to the computer. When trying to upload code to the remote make sure the CoDrone is off. The BLE module should be blinking red, please check out this tutorial. If you are still having issues please send me a video so I can help troubleshoot. Let me know if you have any other questions.