Received, Built, a few issues...

[zumialgorithm]

Just started building Zumi with my Son and found that we do not have a mounting bracket. We have stopped at step 8 of quick start guide.

[robolink_leila]

@wishek ,
For the update issue reverting back to 1.0, could you take a video of the issue?

[robolink_leila]

@JetForMe We'll keep that in mind!

[JetForMe]

@robolink_leila Oh! Haha. Just goes to show you how important details are in a drawing. A tiny light grey border around the edges of the black square would help all the grey out as background and not switch.

[robolink_leila]

Hi @jetforme, the black part in the diagram is the switch. If it's to the left, it is in the off/charging position.

[JetForMe]

Another issue: I think the last page of the manual incorrectly identifies the on/off switch positions.

[JetForMe]

@robolink_leila Thanks, I found that video a couple days ago and used those steps.

[robolink_leila]

@wishek ,
Thank you for your feedback! I've sent this over to the team and I will get back to you about the firmware version issue and the zumidashboard.ai issue. For charging the battery, plug in the USB and make sure to switch Zumi to the "off" position. A red LED will indicate that Zumi is charging.

[robolink_leila]

@JetForMe ,
Refer to this video for an alternate build using only 2 long socket standoffs. We'll be sure to keep you updated on when the right parts should be coming in.

[JetForMe]

Mine was dropped off in the last 20 minutes and I started building it, and ran into this exact problem. I don't have suitable standoffs in my inventory, and I’m not sure how some kid using this to learn is expected to.

Update: It seems perhaps the 3x long plug standoff can be used here, and the 2x socket standoff used later, in step 7.

Update 2: Ah, no, not quite. The forward standoff needs to be a socket type, as it needs to accept a screw from the top to hold the mounting bracket.