Welcome to the Robolink Community forum!
Crisscrossed wires on harnesses
-
The middle two on the black harness appear to be crisscrossed, and the red and black appear to be crisscrossed on the colored harness.
This doesn’t seem right to me. I can’t find a proper wiring diagram to verify. All I’ve found were pictures of the wires. Can someone verify this?
I called their office, but they told me they can’t help me and to post it here.
Thank you.
-
-
@armando9000 We apologize for the trouble but I am glad you could get it fixed!
-
Oh cool thanks!
Don’t worry about it, I can easily swap them. Those wires are easy to replace. There’s simply a tab holding the wire in. If anything I could simply cut and splice them.
No offense, but I don’t want to wait another week for a defective part when I can fix it. I just want to get it up and running!
-
Hi @armando9000 ,
The black 4-pin connector is supposed to be crossed in that way. I understand it can look misleading!
For your 3-pin colored connector, that is definitely incorrect and it may damage your board if you power it on. Thank you for bringing this to our attention! I will contact you shortly to your email associated with your forum account so that we may get a replacement out to you.
