Welcome to the Robolink Community forum!
CoDrone Lite won't pair with Blockly
-
I am trying to pair the Codrones I have with Blockly. I meet the computer requirements. I keep getting no compatible devices found. I have the drone paired to the transmitter and the transmitter connected via USB. Any suggestions would be welcome. Thanks.
-
@verdicchio If you have tried to pair to CoDrone using Blockly without any device connected then it is likely that your device is not enabled with BLE (Bluetooth Low Energy). Since we have phased out Snap! and we are solely using our web-based coding software, you will need to have a BLE enabled device. Most recent laptops and Chromebooks will not be an issue but desktop computers and older laptops will not work.
-
@robolink_leila I am also getting this error without the board or anything connected. Any ideas?
-
@robolink_leila What if the computer does not have bluetooth built in? We used to use Snap! and the codrone IDE with the boards to connect. Are you saying that Blockly can only work if the computer has built-in bluetooth support?
-
@hmeenen For Blockly programming with CoDrone Pro/Lite, you do not need the Bluetooth board to be connected to the device. Make sure the Bluetooth board is off and disconnected so the drone does not pair to it. Try pairing again on Blockly with the battery in the CoDrone only. Hope this helps!