https://edu.workbencheducation.com/cwists/preview/38187x this comes with instructions on how to install snap. The website has lessons with it to learn how to fly your drone with Snap. The Snap program has a block called flight events that contains take off and landing options.

@code-y-cant-code here is my code that I was testing.

I recently attempted to write a code that would allow me to control my codrone with my laptop keys. This included a forever loop that set throttle, yaw, pitch, and roll every half second. I then proceeded to test the code. I landed the codrone softly, but the drone promptly disconnected and my BLE board turned off despite being connected. I assumed I may have sent too much information at once. I then re-calibrated the drone and re-plugged in the BLE board. The board then attempts to pair with the drone, but once it does the board shuts off and no lights are present again. I'm not sure if I am doing something wrong or if my board just broke. Anyone have any insight?