@robolink_leila
I had tried all three USB ports on the front of the computer. I moved it to the back of the computer to the USB ports that are soldered to the motherboard and it worked. I will test again later today and keep my fingers crossed.
As of September 2021, we have moved technical support to Robolink Help
Welcome to the Robolink Community forum!
You can post here to interact with others in the Robolink community. We're checking it weekly, and we'll respond to some messages. If you're looking for technical support, head over to Robolink Help.
R
Latest posts made by rcase35
-
RE: CoDrone Pro No Bluetoothposted in CoDrone Troubleshooting
-
CoDrone Pro No Bluetoothposted in CoDrone Troubleshooting
This is my situation. The previous class departs our lab. We have 4 minutes for class transition. The reading of the daily announcements takes a maximum of 5 minutes. What this means is that that if I avoid my hall supervision, I have roughly 9 minutes to get the drone connected to the computer and ready to program. My problem is that I have never been able to get it connected in less than 30 minutes. If I cannot get this connected in under 9 minutes, it is of no use to me. I am running Windows 10 as an OS. Here are the steps I have tried.
I installed Python 3.7
I opened the command prompt as an administrator and used the
pip install –upgrade pip
command.
I typed the next command of
python –m pip install jupyter
I start the jupyter notebook.
jupyter notebook
I select the new Python 3 menu.
I downloaded and installed the driver.
I extracted the zipped files.
I ran the executable file.
Using Jupyter, I installed CoDrone.
The UART cable is disconnected, the USB cable is connected to my computer and the BLE LED is blinking red. I connected the CoDrone battery and ran this code.
I have previously had it connected to this computer, but I do not know why it connected. I repeated this same process 4 times and on the 4th time it connected. I shut down the computer, did a restart, and it would not connect again. On the second attempt at connection, I started at running Jupyter Notebook and trying to connect. It would not connect. I ran through the entire installation process and it would not connect. Can anyone find an issue with my installation sequence? -
No Connectionposted in Educators Corner
I hope you are having a good morning. My frustration continues.
I have done and redone the lessons of 1B, 1D, 1F, and 1G.
I never get the RoboLink to connect to the drone. I have a flashing red LED on the RoboLink and a flashing green LED on the drone. I have connected to a different USB port, pulled the drone battery, pressed the reset button on the RoboLink. Nope, Nada, Not happening.
Any ideas?
