In other words, is it possible to archive previously compiled & downloaded hex code from the remote even if the original source code is no longer available?

Is it possible to save the current machine program in the remote, even without the source code, in order to then later download that same machine code into the remote, without having to compile any source code?

Oops, I wasn't able to email the videos because apparently I don't have the right privileges. Is there anyway for me to upload the videos? (Actually I sent them via email already.)

Also, you didn't answer my question about whether the remote should be off when calibration? Even if that doesn't matter, for a newbie, removing that uncertainty helps a lot.

Regarding the switch, can I check it by removing the top half of the chassis? How can I do that?

Thanks,

Reggie

Thanks for the reply, Leila!

1. Did you see the videos I uploaded? Yes, I always reset the battery before trying to recalibrate. Could you check if the expected light sequence shows up? If not, then there's something wrong with the switch? Worst case, can I run a program to calibrate the drone? Sorry, I haven't checked the programming options yet, as I wanted to make sure I got the basics down pat.

2. I'm using the built-in code. Yes, I was careful in adjusting the potentiometers. Again, worst case, can I run a basic OTS program to test the infra red sensors?

3. I was just wondering how the drones & remotes in the same area know which exact device to pair up with when there are multiple pairing requests going on?

@reggiehg hmmm I tried uploading my videos here, but I get the message that I don't have the privileges?

1. I can fly my Co-Drone for the most part, but

2. I can't calibrate it, despite watching & imitating the calibration videos (2) several times. Does it matter if the remote is on or off? Any other solution?

3. The hard landing & soft landing infrared sensors don't work either, despite trying to calibrate it with the potentiometer through the whole range of maximum & minimum sensitivities. Any other solution?

4. Does the Co-Drone try to pair again with a remote after every power off & power on cycle? I noticed the green rear light blinking again whenever the unit is powered off. How are multiple drones easily paired for use in the same area?

Help! I can take videos if necessary, but where can I post them?

Thanks,

Reggie