@robolink_leila I did get mine working by swapping out the R Pi Zero. I had one around here that I had to find first and then had to solder a GPIO header on it. But the R P Zero was my problem. So how can we go about swapping the bad Pi that came with the Zumi out?
Welcome to the Robolink Community forum!
Best posts made by sealfish
-
RE: Loading....
Latest posts made by sealfish
-
RE: Loading....
@robolink_leila I sure will it’ll be heading your way. I’m sure that’s what it is because I didn’t change anything but the pi and it started working. The GPIO header looked ok without any solder shorting across pins.
-
RE: Loading....
@robolink_leila I did get mine working by swapping out the R Pi Zero. I had one around here that I had to find first and then had to solder a GPIO header on it. But the R P Zero was my problem. So how can we go about swapping the bad Pi that came with the Zumi out?
-
RE: Loading....
I’ve flashed the same microSD card that came with the Zuni two different times with two separate downloads and it does the same thing it never gets past loading. I tried it twice just to be sure the download wasn’t corrupted, which it wasn’t. I tried with a brand new class 10 64GB microSD and it did the same. That’s the smallest empty card that I had. I pulled the drive out of Zuni and powered it on just to see what would happen and it did the same thing that it did with the card in it except it would go past the loading... screen to a screen that says, Zumi can’t wake up X X. I backtracked all the wiring and everything is correct. Apparently there’s a problem somewhere else. How about I send this one back and you send another one to me?
Thanks -
RE: Loading....
That’s all mine does also. I waited till y’all sent the extra part before assembling mine and it will boot till it says loading and that’s it. I tried to leave a video but it said I didn’t have enough privileges. I would really like to get this working soon.